Signal LCS652, Инструкция по установке и эксплуатации, Страница: 7 / 16

-5-
MOUNTING
AMPLIFIER
The SS650 and LCS652 sirens may be mounted above the dash, below the
dash, on a tunnel, or in a rack with the mounting u-bracket provided. Choose
a mounting location convenient to the operator and away from any air bag
deployment areas. Inspect behind mounting area for clearance. Assure
adequate ventilation to prevent overheating. Consider wire routing and
access to connections. Install mounting bracket to vehicle using 1/4"
hardware (not supplied).
If mounting in a rack or console, make sure that mounting bolts do not enter
case more than 1/4".
ELECTRICAL CONNECTIONS
WIRE SIZE AND TERMINATION
When running your wires and making your connections, please adhere to the following
guidelines:
•
RFI: Mount the siren at least 12” from any strobe lights and/or any two-way
radios.
•
The wiring diagram on pages 8 shows the minimum wire size used for each
connection. If the wire is longer than 10 ft. we recommend the use of the next
larger wire size.
•
If using your own connectors, use only high quality crimp connectors.
•
Make sure all connections are tight.
•
Route wiring to prevent wear, overheating and interference with air bag
deployment.
•
Use grommets and sealant when passing through compartment walls.
•
Minimize the number of splices to reduce voltage drop.
•
Ground connections should only be made to substantial chassis components,
preferably directly to the negative of the vehicle battery.
•
Install and check all wiring before connection to the vehicle battery.