SIGMATEK RAE 100, Руководство пользователя, Страница: 15 / 76

REMOTE ACCESS HOW TO
07.10.2021 Page 15
4 Remote Access Embedded Setup
4.1 Requirements
The RAE package was developed especially for the operating system Salamander, which is
the prerequisite for the software solution.
•
To install RAE on the SIGMATEK control, the OS version must be:
o
Salamander >= 09.03.102.
•
The SIGMATEK control on which RAE100 is installed must have a valid IP
configuration with access to the Internet.
4.2 Setup
This process describes the test procedure for preparing a SIGMATEK control with RAE.
The remote product must be registered after setup.
1. Open LASAL Class 2 and establish a connection to the HMI.
2. The IP configuration can be set via LASAL CLASS 2: "Debug
→
File Transfer
→
Edit Autoexec.lsl" as shown in Figure 4.13.
3. Apply settings valid for the current LAN (Figure 4.14):
a. IP address
b. IP subnet
c. IP gateway: IP address of the router used to access the internet
d. IP DNS: IP address of a DNS server reachable from the current location,
some server addresses are given below:
i. Cloudflare 1.1.1.1
ii. Google 4.4.4.4 or 8.8.8.8
4. Using the PLCDiag tool File Commander under "Tools
→
Advanced Debug Tools
→
File Commander" create the folder "C:\lslsys\packages" on the machine if it does
not already exist.
a. To create a folder use "MAKE DIR" (Figure 4.15, Figure 4.16).
b. Copy the RAE to the packages folder. To do this, navigate to the package
on the right side of the File Commander and click on "COPY" (Figure 4.17).
5. To install RAE, enter the command in the Command Line Interface.
a. Open the Remote CLI under "Tools
→
Advanced Debug Tools
→
Remote
CLI" (Figure 4.18).