USER MANUAL
ZIRC
All information are correct at the time of release. Sigma Designs owns the proprietary rights to the information contained herein this document. It may not be
edited, copied or circulated without prior written agreement by Sigma Designs.
© 2011 Sigma Designs, Inc.
QUICK START GUIDE
Using ZIRC in Z-Wave Mode with STB
Step 1.
Enable STB Z-Wave Add-Node (refer to STB User Manual)
Step 2.
Insert 2 x AAA batteries into ZIRC.
ZIRC in Factory Default state will be Z-Wave Learn Mode once battery is
inserted.
Step 3.
Wait for indication.
GREEN Light flashes 3 times indicating Successful operation.
X 3
Flashes 3 times for Successful operation
OR
RED Light flashes 3 times indicating Fail operation.
X 3
Flashes 3 times for Fail operation
If operation fail, RESET ZIRC to Factory Default (refer to section “
RESET
TO FACTORY DEFAULT”
), and repeat Step 1 to 3 in this section.
Using ZIRC in Infra-Red Mode with STB
Step 1.
Insert 2 x AAA batteries into ZIRC.
Step 2.
Press-and-Hold SETUP and RED for 5 sec
Step 3.
Wait for indication.
GREEN Light flashes 1 times indicating Successful operation.
X 1
Flashes 1 time for Successful operation
Step 4.
YELLOW Light flashes 1 times with any key pressed on ZIRC indicating
ZIRC is in Infra-Red Mode.
X 1
Flashes 1 time for any key pressed
indicating ZIRC is in Infra-Red Mode
