Sight mark 1x24 Goggle Kit, Руководство пользователя

Страница: 8 / 12

5
USE AND TESTING:
Make sure the batteries have been installed according to instructions found above.
• If you wish to test your night vision device in a lighted area, be sure the lens cap is in place prior to pressing the “ON” button.
The lens cap has a pinhole opening to admit a small amount of light for testing purposes.
• Move into a dark area before activation the monocular.
• Remove the lens cap from the objective lens. (1).
• Activate the device by pushing the “ON” button (2). The green LED indicator will light up.
• If the subject to be viewed is in a completely dark area including lowlight shadow areas, activate the infrared illuminator (3)
by pressing the “IR” Button (4) located next to “ON” button.
• Direct the turned on unit at an object at a distance of around 30m. Rotating the eyepiece (5), focus on the tube’s screen
until it becomes focused. Rotate the objective lens (1) until the image quality is optimal. Re-focus the eyepiece, if necessary.
Note: When screwing the objective lens into the housing, it focuses on farther objects. When screwing out it focuses on
closer objects.
(2) button (the green LED indicator will go out) and put it into the carrying case.
BATTERY INSTALLATION:
Your monocular runs on two AA batteries. To install, unscrew the screw of the battery compartment cover, open the
cover and insert the batteries into the battery compartment observing the marking on the inner side of the cover of
the battery compartment, tighten the screw of the cover carefully. Do not overtighten.
• Do not subject the unit to water submersion, drops, or splashes.
• Avoid dropping or otherwise shocking the unit. The monocular incorporates a sophisticated optical system which
could be damaged in extreme cases of misuse.