Installation manual
Инструкция
по
монтажу
CSF_HW_TUBE_R_R
PN 010817
/CSF/HW/BI/EU
CONDENSATE DRAIN CONNECTION
-
For a good drainage , the exhaust pipe must be positioned with a downward inclination of at least 1-2 %.
- Do not wrench or bend the drain hose or flood ist and by water.
- When the drainage tube passig through wet and heat space, should wrap the insulation material.
HYDRAULIC CONNECTION
- comply with the inlet / outlet as shown on the labels placed on the tubes of the unit.
ELECTRICAL CONNECTIONS
The electrical connections must be performed by specialists, according to the National electrical standards in
force.
Before making any connection the power must be turned off.
Use the appropriate wire gauge to the maximum drawn current as shown on the label of the technical data
on the unit.
Connect respecting the instructions given in the scheme attached, according to the unit typology and
accessories.
After the wiring, the wires must be securely fixed to the structure to prevent any snag during the
maintenance operations to adjacent devices.
-
For a good drainage , the exhaust pipe must be positioned with a downward inclination of at least 1-2
%.
- Do not wrench or bend the drain hose or flood ist and by water.
- When the drainage tube passig through wet and heat space, should wrap the insulation material.
HYDRAULIC CONNECTION
-
comply with the inlet / outlet as shown on the labels placed on the tubes of the unit.
ELECTRICAL CONNECTIONS
The electrical connections must be performed by specialists, according to the National
electrical standards in force.
Before making any connection the power must be turned off.
Use the appropriate wire gauge to the maximum drawn current as shown on the label of the technical
data on the unit.
Connect respecting the instructions given in the scheme attached, according to the unit typology and
accessories.
After the wiring, the wires must be securely fixed to the structure to prevent any snag during the
maintenance operations to adjacent devices.
The incorrect connection and/or the failure to respect the National regulations void the
guarantee and any other responsibility of the manufacturer.
CLEANING AND MAINTENANCE
Before maintenance, make sure the power of the unit is turned off.
Only qualified specialists can intervene.
The only component of the fan-coil that needs cleaning and maintenance is the filter, placed on the air
intake (unless there is the breakage of other components).
The filter must be cleaned with every season change, using a vacuum-cleaner or brushing it.
To perform this operation, follow the steps below:
- forcibly pull the panel for the spacific angleform the two ends of the panel according arrow direction.
- pull the air filters downwards to remove it.
6
