9...Use your hobby knife to open the control
horn slots in both the rudder and elevators.
Insert the rudder control horn through the
slot so that the arm sticks out on the left side
of the rudder. Insert the elevator control
horn from the top so that the arm sticks
down from the bottom of the right elevator.
Now slide the retainer plates onto the horns
with their locating pins facing the foam.
Firmly press the clip in place until you hear
or feel two "clicks", indicating that the clip
is securely locked in place.
7
GOOD
BAD
BAD
90
O
GOOD
To apply the decals, leave the clear plastic in
position while you cut the individual mark-
ing from the main sheet. When ready to
apply the decal, remove the clear plastic and
place the decal in the desired location, adhe-
sive side down. Make sure you get the decal
exactly where you want it. The light tack
adhesive allows the decal to be picked up
and repositioned if necessary. With the
decal in the proper position, use a brush or a
12...Plug the airborne electronics together and test for proper function. The two servos are plugged into channel 1 (normally
aileron) and channel 2 (normally elevator) on the receiver. The electronic speed control plugs into channel 3 on the receiver. When
doing this, make very sure that you have installed the three plugs with the correct polarity! Then plug the motor, without the
propeller, into the “motor" side of the ESC. Make sure your transmitter and airborne battery pack are fully charged.
soft rag to generously apply cold tap water to the paper. The paper will immediately begin to soak up the water. Let the paper com-
pletely soak for at least 1-2 minutes. Now gently SLIDE paper from the top of the decal. DO NOT try to move the decal on the
model's surface. The decal is very thin and fragile. If the decal has air bubbles under it, use a soft cloth to gently pat out the bub-
ble, making sure you pat straight up and down, not sideways. DO NOT try to push the bubbles sideways from beneath the decal.
While these decals are more fragile than normal decals, the end result is a marking that looks as if it were painted on. Allow the
decals to completely dry for at least an hour or two before handling.
10... Temporarily attach the lower wing to the fuselage with
two rubber bands. Use 5-minute epoxy to glue the
stabilizer and elevator assembly in place on the fuselage.
The stabilizer should be roughly parallel to the wing and
should not be tilting to the left or right. The slot in the
stabilizer should be centered with glue seam in the fuselage
and must remain free of glue. Use straight pins to hold the
stabilizer in position until the epoxy sets. After the glue
dries, the bottom wing can be removed.
11...Use 5-minute epoxy to glue the fin and rudder
assembly in place. The bottom of the fin must be glued on
top of the stabilizer, while you simultaneously glue
the "tab" at the bottom front of the rudder into the
corresponding slot at the rear of the fuselage. Make sure
the fin and rudder are 90
O
to the horizontal and does not tilt
to the left or right. Use straight pins to hold the fin in place
until the epoxy sets.
Содержание SIGRC95ARF Fokker D.VII
Страница 1: ......