.
23. Fit and glue C-6 into position. Now add the remaining four 3/32" sq. stringers to the cowling assembly.
24.
Glue C-7 to the front of C-4.
25.
Make the removable nose block by laminating parts C-8, C-8a, C-9 and C-10 together.
26.
Place the noseblock on the front of the cowling and sand this assembly to shape. Drill the hole in the nose block for the
propeller bearing making sure to establish the proper amount of right and down thrust.Remove the noseblock from the
cowling.
27.
Glue the landing wire into the slot on the front of the fuselage making sure that it is straight and that the model sits level.
28.
Glue the cowl to the fuselage.
29.
Build the two cabane struts over the plan using 1/16" x 3/16" spruce. Sand a bevel on the top inside edges and round off
the front and back edges of each strip.
Building the Tail Surfaces
30.
Build the Rudder over the plan using parts R-3, R4, and R-5. The remaining structure is made from 3/32" sq. balsa.
31.
Build the Stabilizer using parts S-1 and S-2. The remaining structure is made from 3/32" sq. balsa.
32.
Build the two elevators using parts E-1, E-2 and E-3. The remaining structure is made from 3/32" sq, balsa.
NOTE: The Elevators are not glued to the stabilizer until the model has been covered and the Stabilizer has been installed
in the fuselage.
33.
Sand the edges round and smooth. Test fit the Stabilizer into the fuselage and trim the slot if necessary to obtain a good fit.
NOTE: The Stabilizer should fit a little loose in the fuselage because it will be slightly thicker after covering.
Building the Top Wing
34.
The top wing is built in one piece over the plan and has no dihedral. Cover the wing plan with wax paper.
35.
Glue the wing tip pieces T-6 and T-7 together over the plan. When the glue is dry, remove them from the plan and set
aside.
36.
Glue 3 sets of center trailing edge pieces T-1 and T-2 together. Now laminate these three sets of parts and pin in their
proper position over the plan.
37.
Pin the 3 pieces of the 3/32" sq. lower spar into position over the plan. Pin the two 3/32" x 1/4" trailing edges to the plan.
38.
Bond the two T-3A ribs to rib T-3, and glue into position on the lower spars and T-1/T-2 pieces.
39.
Glue the two T-4 ribs into position and then glue the ten T-5 ribs into position.
4O.
Trim, fit and glue the three pieces of 1/8" sq. leading edges into position.
41.
Glue the wing tip assemblies into position.
NOTE: Be sure to raise the outer edge of the wing tips 1/8" wbile gluing them into position.
42.
Glue the two T-8 ribs into position. Glue the 3/32" sq. top spar into position. Bevel the ends to match the wing tips as shown
on the plan. Glue the 1/16" sq. strips into the notches into the wing ribs. The forward strip ends against rib T-8 and the rear
strip is beveled to match the wing tip like the top spar.
43.
Remove the top wing from the plan and sand all of the outside edges round, taper the trailing edge and sand the assembly
smooth all over.
Содержание HRR111
Страница 3: ... ...