.
75.
Your model is now complete. You MUST READ AND FOLLOW all of the safety rules. We hope that you have enjoyed
assembling your model and hope that you enjoy many fine flights.
Your First Flights
1.
Make sure that all flying surfaces are
straight and warp free.
Safety Rules
1.
Fly your model in a large open area that is free of obstructions, people or their
property.
2.
Do not fly your model in the vicinity of power lines, trees, streets or buildings.
3.
Never try to retrieve any model stuck in power lines, in trees or on a roof or
other high place.
4.
Position yourself at least 150' from spectators before launching model.
5.
Never launch model directly at another person or other object.
6.
Never stick your fingers into a spinning propeller. Do not try to stop a spinning
propeller with your hand or fingers. Never stick any object into a spinning
propeller.
7.
Fly your model only on calm days. Do not fly when the wind is blowing.
8.
Get proper permission before retrieving your model from private property.
2.
Wind the motor about 100 turns.
3.
Point the nose of the model into any
gentle breeze that may be blowing.
4.
Release the propeller and after it
starts turning gently toss the model
aiming the nose at a point on the
ground 100' in front of you. Adjust the
model to circle while increasing the
number of turns in the motor.
Adjustments can be made by gently
bending the tail surfaces and wing
trailing edge.
5.
A properly trimmed model will circle to
the left while climbing under power,
level out as the power runs down and
transition into a right hand gliding
circle.
WARRANTY
Herr Engineering Corp. guarantees this kit to be free from defects in both materials and workmanship at the time
of purchase. This warranty does not cover any component damaged buy use or modification. In no case shall
Herr Engineering Corporation's liability exceed the original cost of the purchased kit. Further Herr Engineering
Corp. reserves the right to change or modify this warranty without notice.
In that Herr Engineering Corporation has no control over the assembly or use, no liability shall be assumed or
accepted for any damage resulting from the use by the user during construction of the kit or the use of the final
user assembled product. By the act of building this kit and/or using the final user assembled product, the user
accepts all liability.
If the buyer and/or user is not prepared to accept all of the liability associated with this product, he is advised to
immediately return this kit in new and unused condition to the place of purchase for a full refund.
© Copyright SIG Mfg. Co., Inc.
SIG MFG. CO., INC............Montezuma, Iowa 50171-0520
LIMIT OF LIABILITY:
In use of our products, Sig Mfg. Co.'s only obligation shall be to replace such quantity of the product proven to be defective.
User shall determine the suitability of the product for his or her intended use and shall assume all risk and liability in connection
therewith.