15
3. Installation
Unpacking
Check the packaging for any signs of damage. Carefully remove the machine and retain the packaging
until the installation is complete.
Location
The machine should be located in a suitable position and environment. Care should be taken to avoid
moisture, dust, steam, oil or corrosive gases. Place on a secure level surface and ensure that there is
adequate clearance around the machine to ensure natural airflow.
Input connection
Before connecting the machine you should ensure that the correct supply is available. Details of the
machine requirements can be found on the rating plate of the machine or in the technical parameters
shown in the manual. The equipment should be connected by a suitably qualified competent person.
Always ensure the equipment has a proper grounding. Never connect the machine to the mains supply
with the panels removed.
If the power supply voltage continually goes beyond the range of safe work voltage range, it will
shorten the welder life-span. The following measures can be used:
• Change the power supply input.
• Reduce the machines power supply that it is using at the same time;
* Set the voltage stabilization device at the front of power cable input.
3.1 Air Connections
1. Select air inlet mod
You can choose to compress the air through the air pump or though the external oil-water
separator on the rear panel.
2. Connecting air supply to unit
If external connection is selected, please connect the gas line to the external oil-water separator
on the rear panel.
3. Check Air Quality
To test the quality of air, press down the air check button, check if there are any oil or moisture in
the air.
NOTE! Air should be free from moisture, oil or large capital damage may occur to the
machine/torch and your guarantee could be void.
