
Testing
Rev 6 Mar.13
Proprietary and Confidential - Contents subject to change
77
7.
Press
Enter
twice.
8.
Use the down-arrow key to select
Save setup as dfl
.
9.
Select
Exit
.
UMTS RF transmission path test
Note: This procedure segment is performed in
of the
contains parameters used in the suggested test procedure that follows.
To test the DUT’s transmitter path:
Note: This procedure
describes steps using the
"Power Meter: Gigatronics
8651A” (with Option 12
and Power Sensor
80701A).
1.
Set up the power meter:
a.
Make sure the meter has been given sufficient time to warm up, if
necessary, to enable it to take accurate measurements.
b.
Zero-calibrate the meter.
c.
Enable MAP mode.
2.
Prepare the DUT using the following AT commands:
a.
AT!ENTERCND=”<password>”
(Unlock extended AT command set.)
b.
AT!DAFTMACT
(Enter test mode.)
c.
AT!DASBAND=<bandValue>
(Set frequency band.)
·
See
for appropriate <bandValue> values
Table C-1: Test settings — Transmission path
Mode
Test
category
Bands
850
900
1800
1900
2100
WCDMA
Band
22
29
n/a
15
a
a. Either 15 (WCDMA1900A) or 16 (WCDMA1900B) may be used for testing.
9
Channel
b
b. Channel values shown are at the center of the corresponding bands.
4182
2812
n/a
9400
9750
GSM
Band
n/a
10
11
12
n/a
Channel
n/a
65
697
661
n/a