41110461XXXX
Rev 0.12
January 16, 2017
12
Hardware Integration Guide
Introduction
1 CS 0.1% BER 12.2 kbps
2 Test at Class A extreme condition
1.3.3.
LTE RF Interface
This section presents the LTE RF Specification for the AirPrime AR758x Series.
1.3.3.1.
LTE TX Output Power
The LTE Maximum Transmitter Output Power of the AirPrime AR758x Series are specified in the
following table.
Note:
The test configuration for all of the entries in the table below is per 3GPP specification,
Connectorized (Class 3).
Note:
All values in the table below are preliminary.
Table 9.
Conducted TX (Transmit) Max output Power Tolerances
– LTE Bands
Band
Standard (dBm)
(Note 2)
Class A (dBm) (Note 3)
Notes
B2
23 ±2.7dB
23 ±2.2dB
Note 1,4
B4
23 ±2.7dB
23 ±2.2dB
Note 1
B5
23 ±2.7dB
23 ±2.2dB
Note 1
B7
23 ±2.7dB
23 ±2.2dB
Note 1,4
B12
23 ±2.7dB
23 ±2.2dB
Note 1,4
B13
23 +2.7/-1.7 dB
23 ±2.2dB
Note 1
B17
23 ±2.7dB
23 ±2.2dB
Note 1
Note 1: The test configurations for all of the entries in the table above are per 3GPP specification, Connectorized (Class
3).
Note 2: Per 3GPP TS 36.521-1 6.2.2 UE Maximum Output Power ( No MPR);and for B13,Per VzW
’s
Supplementary_RF_Conformance. 2.1 Maximum Output Power
– No MPR Or A-MPR
Note 3: Class A is defined in 3.3 Environmental
Note 4: For transmission bandwidths (Figure 5.4.2-1 in 3GPP TS 36.521-1) confined within FUL_low and F 4
MHz or FUL_high
– 4 MHz and FUL_high, the maximum output power requirement is relaxed by reducing the lower
tolerance limit by 1.5 dB.
1.3.3.2.
LTE RX Sensitivity
The LTE Receiver Sensitivities of the AirPrime AR758x Series are specified in the following table.
Note:
For the table below:
Dual receiver (SIMO) per 3GPP TS 36.521-1 Rx Sensitivity Specification.
Sensitivity values scale with bandwidth:
x_MHz_Sensitivity = 10 MHz_Sensitivity – 10*log(10 MHz/x_MHz)
10 MHz BW,and 50 RB DownLink and Up Link RB configuration is as 3GPP TS 36.521-1 Table
7.3.5-2.
All values are preliminary pending transceiver matching and testing.
