Sierra Wireless Airlink Raven XT-Telus, Инструкция по эксплуатации

Страница: 14 / 35

Raven XT-Telus CDMA Sierra Wireless Cellular Modem
x
The Reset button (on the left side of the Raven XT) has two functions. If
it is quickly depressed and released, the modem will simply power cycle
the internal hardware. If, however, the reset is depressed and held for
several seconds (count 10 slowly, and wait for the power light to go off
after the light pattern stops), the ALEOS configuration settings will return
to the factory defaults.
Light Patterns
The LEDs on the front of the modem will respond in different patterns to
indicate modem states.
x
Normal —Each LED, mentioned above, lit as applicable.
x
Start up —The LEDs will cycle from left to right.
x
PassThru mode —Network and Signal LEDs will blink in tandem. The
Activity LED will blink when transmitting or receiving data.
x
SOS —The Network LED blinks.
x
Configuration Reset —The LEDs will cycle left to right and then right to
left 4 times.
x
Authentication Failure —The Network, Signal, and Activity LEDs blink
every 2 seconds.
x
Data Retry —The Network, Signal, and Activity LEDs blink every 3
seconds.
5.2 Using AceManager to Configure the Modem
After the Raven XT has been provisioned, certain settings have to be changed
for the modem to be compatible with CSI dataloggers. The recommended way
to change the settings is to send a template file to the modem using the
AceManager utility.
The AceManager utility is on the CD that ships with the Raven XT modem,
and is available from Sierra Wireless (
http://www.sierrawireless.com/support ).
To install AceManager from the Sierra Wireless CD, click on the
“AceManager” link under Modem Utilities and follow the prompts. Once the
application has been installed, it can be run from the Windows Start menu, or
from the icon on the desktop.
Campbell Scientific’s “Raven XT Template 115200” file is for dataloggers that
support 115200 baud (e.g. CR1000), the “Raven XT Template 9600” file is for
dataloggers that support a maximum baud rate of 9600 (e.g. CR10X). The
template file configures the modem to be compatible with CSI dataloggers.
Template files are available from Campbell Scientific’s Website:
www.campbellsci.com/downloads .
Connect the Raven XT to a com port on the PC with a direct RS-232 serial
cable. Also connect the antenna, and 12V power.
11