en
Faults and what to do about them
34
Faults and what to do about them
E:32
Alternating display with
End
when programme is finished: unbalance problem, spin-
ning phase is aborted.
w
lights up
The childproof lock is activated – deactivate it.
o
lights up
Too much foam has been detected and an additional wash cycle has been acti-
vated. Add less detergent to the next washing cycle with the same load.
k
flashes
Run the
Drum clean
programme to clean and care for the drum and the outer tub.
Notes
■
Run the programme without laundry.
■
Use washing powder or a detergent containing bleach. To prevent foaming,
only use half the amount of detergent recommended by the detergent manufac-
turer. Do not use detergent designed for woollens or delicates.
■
Switching the information signal on/off.
Other displays
Switch off the appliance, wait for five seconds and then switch it on again. If the dis-
play appears again, call customer services.
Faults
Cause/Remedy
Water is leaking from the
appliance.
■
Attach the drain hose correctly or replace it.
■
Tighten the screw fitting on the supply hose.
The appliance is not filling
with water.
Detergent is not being dis-
pensed.
■
Programme does not start?
■
Is the tap turned on?
■
Could the filter in the water supply be blocked?
"Filter in the water supply is blocked" on page 32
■
Is the supply hose kinked or trapped?
The wrong detergent/fab-
ric softener has been
poured into the dis-
penser(s).
Dispenser(s):
1.
Empty and clean.
2.
Refill.
Detergent/fabric softener
has congealed in the dis-
pensers.
Clean and refill the dispensers.
The door cannot be
opened.
■
The safety function is activated. Stop the programme?
■
Can the door only be opened by the emergency release?
"Emergency release" on page 33
■
Childproof lock activated? Deactivate childproof lock.
■
The temperature in drum is too high to open the door. Wait approx. 30 sec-
onds until the temperature in drum cools down.
■
The water level in drum is too high.
Display
Cause/Remedy
Содержание WU P Series
Страница 39: ...6 ...
