Siemens WU P Series, Инструкция по эксплуатации и руководство по установке

Страница: 33 / 40

Faults and what to do about them
en
33
3
Faults and what to do
about them
Faults and what to do about them
Emergency release
E.g. in the event of a power cut
The programme continues when the
power supply is restored.
However, if the laundry has to be
removed, the appliance door can be
opened as follows:
:
Warning
Risk of scalding!
When you are washing at high
temperatures, there is a risk of scalding
if you come into contact with hot water
and laundry.
If possible, leave it to cool down first.
Caution!
Risk when reaching into/gripping the
rotating drum!
You may injure your hands if you reach
into the drum while it is turning.
Do not reach into the drum when it is
turning.
Caution!
Water damage!
Any escaping water may cause water
damage.
Do not open the door if water can be
seen through the glass.
1.
Switch off the appliance. Pull out the
mains plug.
2.
Drain the water
.
3.
Pull the emergency release
downwards with a tool and release.
The door can then be opened.
Information on the display panel
Display Cause/Remedy
Õ
■
Flashes fast + warning signal : The door was opened and the water level is
too high. Close the door, continue the programme with
A
Start/Reload
but-
ton or select
Spin
programme.
■
Flashes slowly
: The door lock temperature is too high to open the door. Wait
approx. 30 seconds until the door lock temperature cools down.
|
■
Flashes (no water supply): Tap turned on? Filter in the water supply is
blocked?
~
"Filter in the water supply is blocked" on page 32
Is the supply hose kinked or trapped?
■
Lights up (low water pressure): For information only. This will not affect the
programme progress. The programme duration is extended.
E:18 Is the drain pump blocked?
~
"Drain pump is blocked" on page 31
Is the drain hose at the siphon blocked?
~
"The drain hose at the siphon is blocked" on page 32