Cleaning and maintenance
en
31
Cleaning the measuring aid A
*
for liquid detergent
If it contains liquid detergent residue:
1.
Hold the mearsuring aid, pull the
cover upward and disconnect them.
2.
Clean the measuring aid and cover
with water and brush.
3.
Install the cover back to the
measuring aid. Pay attention to the
assemble mark, and press the cover
until click sounds.
Drain pump is blocked
Note:
Turn the tap off to prevent more
water from flowing in and to ensure that
it is drained via the pump.
:
Warning
Risk of scalding!
When you wash at high temperatures,
the water gets very hot. If you come into
contact with the hot water, you may be
scalded.
Allow the water to cool down.
1.
Switch off the appliance. Pull out the
mains plug.
2.
Open the service flap.
3.
Take the drain hose out of the
retainer.
Remove the sealing cap and pour
the water out into a suitable
container.
Replace the sealing cap and place
the drain hose back in the retainer.
4.
Carefully unscrew the pump cover;
residual water may leak out.
Clean the interior, pump cover
thread and pump housing. The
impeller in the drain pump must be
able to rotate.
Refit and screw on the pump cover.
The handle must be in a vertical
position.
* depending on the model
Содержание WU P Series
Страница 39: ...6 ...
