en
Positioning and connecting
18
Before washing for the first
time
The appliance was inspected
thoroughly before leaving the factory. To
remove any residual test water, run the
Drum clean
programme the first time
without
laundry.
Note:
■
The appliance must have been
installed and connected properly.
■
Never switch on a damaged
appliance.
1.
Insert mains plug.
2.
Turn the tap on.
3.
Turn the programme selector to
$
Off
. The appliance is switched on.
4.
Close the door. Do not load any
laundry.
5.
Select the
Drum clean
programme.
6.
Open the detergent drawer.
7.
Pour approx. 2 litre of water into
dispenser
II
.
8.
Add standard detergent to
dispenser
II
according
to manufacturer’s instructions for
light soiling.
Note:
To prevent frothing, use only
half the recommended amount
of detergent. Do not use any
woollens or mild detergents.
9.
Close the detergent drawer.
10.
Select
A
Start/Reload
.
11.
When the programme ends, turn the
programme selector to
$
Off
. The
appliance is switched off.
Your appliance is now ready for use.
Transportation
e.g. when moving home
Preparatory work:
1.
Turn off the water tap.
2.
Reduce the water pressure in the
supply hose.
3.
Drain any residual water.
4.
Disconnect the appliance from the
mains.
5.
Remove the hoses.
6.
Empty the dispensers.
"Detergent drawer and housing"
measuring aid A for liquid detergent"
Installing the transport locks:
1.
Remove the covers and keep them
in a safe place.
Use a screwdriver if necessary.
2.
Insert all four sleeves.
Clip the mains cable securely in the
holders. Insert and tighten the
screws.
Before switching on the appliance
again:
Notes
■
The transport braces
must
be
removed.
"Removing the transport locks"
■
Pour approx. 2 litre of water into
compartment II, select the
spin
programme or
rinse
and start.
This will prevent detergent from
flowing straight into the drain during
the next wash.
Содержание WU P Series
Страница 39: ...6 ...
