Cleaning
en
41
13.
Carefully tilt the condensation
container back and forth to rinse
away any remaining care product,
and then empty the condensation
container completely.
14.
Pour approximately 1
^
litres of hot
tap water into the empty
condensation container again.
15.
Push the full condensation container
horizontally into the dryer until you
feel it lock into place.
16.
Press the Start button.
The appliance care programme will be
resumed.
Once the appliance care programme
has ended,
“Ÿš
will appear on the
display panel and an audible signal will
sound.
17.
Pull out the condensation container.
18.
Empty the condensation container,
reinsert it fully and switch off the
dryer.
You have now completed the appliance
care programme.
Cleaning the air shaft
To ensure that you achieve optimal
drying results again and again, you can
clean the air shaft. To clean the air
shaft:
1.
Open the maintenance flap.
2.
Unlock the levers on the cover, then
take hold of the gripping area on the
cover and pull it out.
3.
Use a soft brush to clean the cover.
Note:
When cleaning the cover,
make sure that no dirt or debris is
left on the seal.
4.
Pull out the insert horizontally.
5.
Rinse the insert under running water.
6.
Remove any fluff or debris that has
found its way into the air shaft.
7.
Slide the insert back in as far as it
will go.
