en
Faults and what to do about them
36
3
Faults and what to do about them
Faults and what to do about them
Faults
Cause/remedy
Ì
on the display panel
and drying has been
interrupted.
■
Empty the condensation container and press the Start button
.
■
If the optional condensation drain* is installed, the drain hose may be
blocked or kinked. Check the hose for deposits and rinse the hose. Lay the
hose without any kinks.
¥
on the display panel. Clean the fluff filter and press the Start button
selfCleaning on the
é
display panel.
Not a fault. The heat exchanger is cleaned automatically. Do not pull out the
condensation container while this is displayed.
Dryer will not start.
■
Mains plug plugged in or fuse checked?
■
Programme selected? Select a programme.
■
Dryer door open? Close the door.
■
Is the childproof lock activated? Deactivate childproof lock.
■
"Ready in" time selected? Programme starts after a delay
.
Creasing.
■
Creasing occurs when you have exceeded the maximum load or selected
the wrong programme for the type of fabric. All the required information
can be found in the programme table
.
■
Remove clothes immediately after drying; creasing will occur if they are left
in the drum.
Water is leaking out.
Not a fault; the dryer may be sloping. Level the dryer.
Change in the pro-
gramme duration dis-
played during drying.
Not a fault. The moisture sensors detect the remaining moisture in the load and
adjust the programme length (except timed programmes).
Laundry is not dried cor-
rectly or is still too damp.
■
After the programme has ended, warm laundry feels damper than it actu-
ally is. Spread the laundry out and allow the heat to disperse.
■
Finely adjust the dryness level – this extends the drying time but does not
increase the temperature. Your laundry will become drier
■
Select a programme with a longer drying time or increase the dryness level.
This does not increase the temperature.
■
Select a timed programme to add extra drying time for laundry that is still
damp
■
If you have exceeded the maximum load for the programme, the laundry
may not be dried properly.
■
Clean the moisture sensor in the drum. The sensor may become covered by
a fine layer of limescale or residues of detergents and care products which
then impair its function. Your laundry is not being dried correctly
.
■
Drying has been interrupted as a result of a power cut, because the conden-
sation container is full or because the maximum drying time has been
exceeded.
Note:
See also the laundry tips
* Depending on the model
