Siemens WP13T483BY, Инструкция по эксплуатации

Страница: 28 / 32

28
What to do if...
Problem
The programme does
not start
Severe vibrations during
the spin cycle
The laundry was not or
was insufficiently spun
dry
Water issues from/under
the machine
The machine does not
drain out
The lid does not open
The drum lids open too
slowly
Possible cause / Remedial action
• The selection of the programme was not fully completed:
- The ”Start/Pause” pushbutton has not been pressed.
- Programme selector remains in the Stop position.
• The washing machine is not supplied with power:
- Check if the appliance plug is connected.
- Check protection devices.
• The tap is closed.
• The inlet hose is torn
• The lid is not properly closed.
• The transport securing devices for the appliance have not been
completely removed:
- Check if all the transport securing devices have been removed.
(see chapter entitled REMOVING THE TRANSPORT SECURING
DEVICES)
• The floor is not level.
• The washing machine rests on both ”front” castors.
- Push the locking lever towards the right.
• You have chosen a programme without a spin cycle, i.e. ”Gentle Spin”.
• The imbalance control system has detected an improper distribution
of laundry in the drum:
- Resort the laundry and again select ”Spin”.
• The drain hose is improperly inserted into the drainage line.
• The water inlet hose leaks at the machine and at the tap:
- Check the gaskets and connections.
• ”Rinse Stop” was chosen.
• The drain hose is broken or crimped.
• Place drain hose on the floor and collect water in an appropriate
glass.
It is absolutely necessary to replace the hose bracket if the
appliance is an Aquastop model !
• The drain pump filter is blocked:
- clean the filter (see chapter entitled CLEANING THE FILTER)
• The programme has not yet ended.
The lid remains locked during the entire time of the programme.
• The washing machine has not been used for a long time.
• The washing machine is in a room that is too cold.
• Residual detergent (powder) is blocking the hinges.
- Remove residual detergent.
If a malfunction can not be remedied with the assistance of the following chart:
•Turn programme selector to ”Off”.
• Disconnect washing machine from mains.
• Turn off tap.
Risk of electrical shock!
Have repairs carried out only through Customer Service or by authorised specialists.