Siemens WM16Y791DN, Инструкция по эксплуатации и руководство по установке

Страница: 35 / 60

35
4.
Remove sealing cap, allow detergent solution to flow out.
Have a suitable container ready.
Push up the closing cap and place the drain hose back in its
holder.
Note: Residual water may run out.
5. Carefully unscrew the pump cover. Clean the interior, pump
cover thread and pump housing (fan impeller in the
detergent-solution pump must rotate).
6. Reinsert and screw on pump cover. Handle should be
vertical.
7. Close the service flap. If required, lock disengaged service
flap beforehand.
²
To prevent unused detergent from flowing into the outlet during
the next wash: Pour 1 litre of water into dispenser
II and start the
Drain programme.
Drainage hose on the siphon blocked
1.
Switch off the appliance. Pull out the mains plug!
Note: Residual water may run out!
2.
Loosen hose clip, carefully remove drainage hose.
3. Clean drainage hose and siphon spigot.
4.
Re-attach drainage hose and secure connection point with
hose clip.