Siemens WM16XK02EU, Руководство пользователя и инструкции по установке

Страница: 31 / 60

operation
en
31
Notes
¡
The programme settings are not
saved permanently for the pro-
gramme.
¡
The setting is saved if you activate
or deactivate the intelligent dosing
system.
13.4 Loading laundry
Note:
To prevent creasing, note the
maximum load for the programmes.
→
"Programmes", Page 25
Requirements
¡
The laundry is prepared and sor-
ted.
→
"Laundry", Page 29
¡
The drum is empty.
1.
Open the door.
2.
Place the laundry in the drum.
3.
Close the door.
Ensure that there is no laundry
trapped in the door.
13.5 Adding detergent and
care product
For programmes in which intelligent
dosing is not possible or desirable,
you can add detergent manually.
Tip:
In addition to intelligent dosing,
you can also add additional care
product for laundry, e.g. stain re-
mover, starch or bleach, to the
manual dosing compartment. Do not
add any additional detergent to the
manual dosing compartment to avoid
overdosage and/or foaming.
Note:
Observe the information about
detergents and care products
→
Page 30 .
1.
Pull out the detergent drawer.
2.
Pour in detergent.
→
"Detergent drawer", Page 18
3.
If required, add the care product.
4.
Push in the detergent drawer.
13.6 Starting the programme
Requirement:
A programme is set.
→ "Setting a programme", Page 30
▶
Press
Start/Reload
.
a
The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a
The display shows the programme
duration or the "Ready in" time.
a
After the programme has ended,
the display shows:
-0-
.
13.7 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
Requirement:
A programme has
started.
→
"Starting the programme",
Page 31
1.
Press
Start/Reload
.
The appliance pauses.
Note:
If you want to add laundry,
follow the instructions on the dis-
play.
→
"Display", Page 22
2.
Open the door.
3.
Add or remove laundry.
4.
Close the door.
5.
Press
Start/Reload
.
13.8 Cancelling the pro-
gramme
1.
Press
Start/Reload
.
2.
Open the appliance door.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the
Rinse
programme.