Siemens WM16XFH5GB, Руководство пользователя и инструкции по установке

Страница: 15 / 76

Installation and connection
en
15
ATTENTION!
If the appliance is installed in areas
exposed to frost or outdoors, frozen
residual water may damage the appli-
ance and frozen hoses may crack or
split.
▶
Do not install or operate this appli-
ance anywhere that is liable to ex-
perience frost and/or outdoors.
The appliance underwent a function
test before leaving the factory and
may, therefore, contain residual wa-
ter. This residual water may leak out
if the appliance is tilted at an angle
greater than 40°.
▶
Tilt the appliance carefully.
Installation loca-
tion Requirements
On a base Secure the appli-
ance with fixing
brackets
→
Page 40 .
On a wooden
joist floor Place the appli-
ance on a water-
resistant wooden
board which is
screwed tightly to
the floor. The
wooden board
should be at
least 30 mm
thick.
In a kitchen unit
¡
A niche width
of 60 cm is re-
quired.
¡
Only install the
appliance un-
derneath a
continuous
worktop that is
securely con-
nected to adja-
cent cabinets.
Installation loca-
tion Requirements
On a wall Do not trap the
hoses between
the wall and the
appliance.
4.4 Removing the transit
bolts
The appliance is secured for trans-
portation using transit bolts on the
rear of the appliance.
Notes
¡
Please read the information in the
Safety →
Page 4 and Preventing
material damage → Page 11 sec-
tions to ensure that you use the
appliance safely.
¡
Keep the transit bolts, screws and
sleeves in a safe place for future
transport →
Page 69 .
1.
Pull the hoses out of the holders.