Cleaning and servicing
en
55
Cleaning the water inlet filter
Clean the filter in the water inlet in the
event of blockages or if the water pres-
sure is too low.
Emptying the water inlet hose
In order to clean the filter, first empty
the water inlet hose.
1.
Turn off the tap.
2.
Set a programme, except for
Rinse /
Freshen Up
,
Spin
or
Drain
.
3.
Start the programme and leave it to
run for approx. 40 seconds.
4.
Switch off the appliance.
5.
Disconnect the appliance's mains
plug from the power supply.
Cleaning the filter on the tap
Note:
Please read the safety informa-
to ensure that you use
the appliance safely.
Requirement:
The water inlet hose is
empty.
1.
Remove the water inlet hose from
the tap.
2.
Clean the filter with a small brush.
3.
Connect the water inlet hose and
check for leaks.
Содержание WM16XFH0ES
Страница 18: ...en Installation and connection 18 In doing so hold the foot tight and do not adjust its height ...
Страница 69: ......
Страница 70: ......
Страница 71: ......