Siemens WM14Y740ES, Инструкция по эксплуатации и руководство по установке

Страница: 39 / 60

39
Information on the display panel
Display Cause/Remedy
The door cannot be
locked, please open
the door again, then
close it and select
"start/pause".
– Washing may be caught. Please open and close washing
machine door again and select
inicio
/pausa+carga
Ü
(
Start
/Pause).
– If required, shut washing machine door or remove washing and
shut again.
– If required, switch appliance off and on again; set programme
and make individual settings; start programme.
Please open tap – Turn on tap fully.
– Supply hose kinked/jammed.
– Water pressure too low. Clean the filter.
~
Page 37
Please clean pump – Drain pump blocked. Clean the drain pump.
– The water drainage pipe/drain hose is blocked. Clean the
drainage hose on the siphon.
~
Page 36
Pause: Reload is not
possible
Water level or temperature is too high.
Select
inicio
/pausa+carga
Ü
(
Start
/Pause) to continue the
programme.
Door cannot be
unlocked: Water
level or temperature
is too high
Water level or temperature is too high.
Select
inicio
/pausa+carga
Ü
(
Start
/Pause) to continue the
programme.
aquaStop has been
activated!
Please call customer
service
not applicable without Aqua-Stop
Water in the base pan, appliance leaking.
Call customer service!
~
Page 42
Auto power-off in ...
seconds,
Appliance automatically switches off after ... seconds if it is not
operated for a prolonged period. In order to cancel the programme,
press any button.
~
Page 32
Cooling down the
detergent solution
To protect the wastewater pipes, the hot detergent solution is
cooled before being drained.
Other displays
Error E: XXX
Switch off appliance, wait 5 seconds and switch on again. If the
display is indicated again, call customer service.
~
Page 42