Siemens WM14W768DN, Инструкция по эксплуатации и монтажу

Страница: 35 / 56

Programme default settings
en
35
Starching
Note:
Laundry should not be treated
with fabric softener.
Liquid starch can be used to stiffen
fabrics particularly in the Rinse and
Cottons programmes. Measure starch
into compartment
M
in accordance with
the manufacturer's instructions (clean
first if necessary).
Dyeing/bleaching
Dye should only be used in normal
household quantities. Salt may damage
stainless steel. Always follow the dye
manufacturer's instructions.
Do
not
use the washing machine to
bleach clothes.
Soaking
1.
Switch on the appliance.
2.
Select the
Cottons 30 °C
programme.
3.
Pour soaking agent/detergent into
compartment
II
in accordance with
the manufacturer’s instructions.
4.
Press the
Ü
button. The programme
starts.
5.
After approx. 10 minutes, press the
Ü
button to pause the programme.
6.
Leave the laundry to soak for as long
as required, then either press the
Ü
button again to continue the
programme or change the
programme.
Notes
■
Load laundry of the same colour.
■
No additional detergent is required;
the soaking solution is used for
washing.
0
Programme default
settings
Programme default settings
The default programme settings are
displayed in the display panel after
selecting the programme.
You can change the default settings.
An overview of all programme settings,
which can be selected depending on
the programme, can be found from
~
Page 30 .
Temperature
(°C)
Depending on what stage the
programme is in, you can change the
set temperature before and during the
programme.
The maximum temperature that can be
set depends on the programme that has
been selected.
Spin speed
(
0
)
Depending on what stage the
programme is in, you can change the
spin speed (in rpm; revolutions per
minute) before and during the
programme.
Setting 0 : The rinsing water is drained
but there is no final spin. The laundry
stays wet inside the drum, e.g. for items
that should not be spun.
Setting
$
: Rinse Stop = no final spin.
The laundry stays in the water after the
final rinse.
You can select “Rinse Stop” to prevent
creasing if the laundry will not be taken
out of the washing machine immediately
after the programme has ended.
To continue/end the programme
~
Page 41