Siemens WM14VEH0CS, Руководство пользователя и инструкции по установке, Страница: 49 / 64

Troubleshooting
en
49
Fault Cause and troubleshooting
"E:30 / -80" Unapproved extension installed on the water drain
hose.
▶
Remove any unapproved extensions from the water
hose. Connecting the appliance
The pump cap is not fully screwed in.
▶
Ensure that the pump cap is screwed in all the way
into the appliance. The handle on the pump cap
must be in a vertical position.
"E:36 / -25 / -26" Drain pump is blocked.
▶
→ "Cleaning the drain pump", Page 44
"E:38 / -25 / -26" Drain pump is blocked.
▶
→ "Cleaning the drum", Page 42
if the fault is displayed again,
▶
→ "Cleaning the drain pump", Page 44
Inlet opening of the rubber gasket is blocked.
▶
→ "Cleaning the intake opening in the rubber gas-
ket", Page 47
i-DOS error, deactiv-
ate i-DOS The pump for the intelligent dosing system is blocked.
1.
Switch off the appliance.
2.
Clean the pump unit.
→
"Cleaning the detergent drawer", Page 43
3.
If this display appears again, call customer service.
→
"Customer Service", Page 59
Note:
You can start the washing programme if you de-
activate the intelligent dosing system and dose manu-
ally.
→
"Buttons", Page 25
All other error codes. Malfunction
▶
Call the after-sales service.
→
"Customer Service", Page 59
Water cooling To protect the wastewater pipes, the hot detergent
solution is cooled before being drained.
▶
Wait until the detergent solution has cooled down.
"E:30/-20" Solenoid valve defective.
▶
Call the after-sales service.
→
"Customer Service", Page 59
Detergent dosage is too high.
▶
If you dose manually, reduce the amount of deter-
gent for the next washing cycle with the same load.
Additional water is added.