Siemens WM14T780ME, Инструкция по эксплуатации и монтажу

Страница: 32 / 48

en
Operating the appliance
32
Placing laundry into the drum
:
Warning
Danger of death!
Items of laundry pretreated with
cleaning agents that contain solvents,
e.g. stain remover/cleaning solvent,
may cause an explosion after being
loaded into the washing machine.
Hand-rinse items of laundry thoroughly
beforehand.
Notes
■
Mix items of laundry of varying sizes.
Laundry items of different sizes
distribute themselves better during
the spin cycle. Individual items of
laundry may lead to imbalances.
■
Observe the specified maximum
load. Overfilling has a negative
impact on the washing result and
promotes creasing.
1.
Place presorted items of laundry
unfolded in the washing drum.
2.
Make sure that no items of laundry
are trapped between the washing
machine door and the rubber seal,
and close the door.
Measure and add detergent
and care products
For the majority of programmes on your
washing machine, detergent and fabric
softener are dosed automatically; it is a
factory setting for these programmes
and can be changed.
In addition to intelligent dosing, you can
add cleaning aids (e.g. softener, bleach
or stain remover) to the left-hand
compartment , if necessary.
For programmes without intelligent
dosing, or as required (in which case,
set intelligent dosing to "off"), detergent
can be added manually to the left-hand
compartment.
Start the programme
Touch the control panel
‹
.
The programme starts and the
‹
display lights up permanently.
The door is locked and the
corresponding display
®
lights up.
During the programme, the current
programme information is displayed:
■
Finish in-timeFinished in-time or, after
the washing programme has started,
the programme duration
■
And the displays for the
programme's progress light up.
~
Page 20
Information on the following programme
steps and settings, which can be
changed during the programme
sequence, light up at half brightness.
Note: Foam detection
If the
o
display also lights up, the
washing machine has detected too
much foam during the washing
programme and automatically activated
additional rinse cycles to remove the
foam.
Add less detergent to the next washing
cycle with the same load.
If you want to lock the programme to
prevent it from being inadvertently
adjusted, you can select the childproof
lock as follows.
Childlock /operation lock
w
3 sec
You can lock the washing machine to
prevent the functions you have set from