en
Troubleshooting
56
Fault
Cause
troubleshooting
The water is not draining.
the programme status is Rinse
Hold", Page 40
The water outlet hose is con-
nected too high.
▶
Install the water outlet hose at a
maximum height of 1 metre.
Detergent dosage is too
high.
▶
Immediate measure: Mix one table-
spoon of fabric softener with 0.5
litres of water and pour the mixture
into the compartment for manual
dosing (not for outdoor clothing,
sportswear or items stuffed with
down).
▶
If intelligent dosing is activated, re-
duce the "basic dosage"
▶
If you dose manually, reduce the
amount of detergent for the next
washing cycle with the same load.
Unapproved extension in-
stalled on the water drain
hose.
▶
Remove any unapproved exten-
sions from the water hose. Connect-
ing the appliance
Water is not flowing in. De-
tergent is not being dis-
pensed.
You have not pressed
Start/
Reload
.
▶
Press
Start/Reload
.
The filters in the water inflow
are blocked.
▶
"Clean the filters in the water in-
flow"
The tap is turned off.
▶
Turn on the tap.
The water inlet hose is
kinked or jammed.
▶
Ensure that the water inlet hose is
not kinked or jammed.
The spin cycle runs several
times.
The unbalanced load detec-
tion system eliminates an im-
balance by repeatedly redis-
tributing the laundry.
▶
Not a fault – no action required.
Note:
When loading, where possible,
place large and small items of laundry
together in the drum. Different sized
items of laundry distribute themselves
better during the spin cycle.
The programme duration
changes during the wash
cycle.
The programme operation is
optimised electronically.
This may change the pro-
gramme duration.
▶
Not a fault – no action required.
Содержание WM14SO8DN
Страница 67: ......
