Siemens WM12Y740IT, Инструкция по эксплуатации

Страница: 41 / 64

41
Display panel/
indicator lights do
not function while
the appliance is
running. – Power failure?
– Fuse tripped? Switch on/replace fuse.
– If the fault occurs repeatedly, call customer service.
~
Page 42
The programme
takes longer than
usual. – Not a fault – unbalanced load detection system adjusts
imbalance by repeatedly distributing the washing.
– Not a fault – foam detection system active – several rinse cycles
are switched on.
Detergent residue
on the washing. – Occasionally phosphate-free detergents contain water-insoluble
residue.
– Select Rinsing or brush the laundry after washing.
In the pause status
Start/Pause
Ü
flashes very quickly
and a signal sounds.
– Water level too high. Washing cannot be reloaded. Immediately
close washing machine door.
– Select Start /Pause
Ü
to continue the programme.
If a fault cannot be rectified (switching the machine on and off) or a repair is required:
– Switch off the appliance and pull out the mains plug.
– Turn off the tap and call customer service.
~
Page 42
Faults Cause/Remedy