en
Positioning and connecting
18
Observe the following information and
ensure that:
Notes
■
The mains voltage and voltage
indicated on the washing machine
(rating plate) are the same.
The connected load and fuse
required are specified on the rating
plate.
■
The washing machine is only
connected to an alternating current
supply via a properly installed
earthed socket.
■
The mains plug fits the socket.
■
The cable cross-section is adequate.
■
The earthing system is properly
installed.
■
The mains cable is only replaced by
a qualified electrician (if this is
necessary). Replacement mains
cables are available from the after-
sales service.
■
No multiple plugs/couplings or
extension cables are used.
■
If an earth-leakage circuit breaker is
used, only a type which displays the
z
symbol is used.
Only this symbol guarantees
compliance with the currently
applicable regulations.
■
The mains plug can be accessed at
all times.
■
The mains cable is not kinked,
squashed, altered or cut through.
■
The mains cable does not come into
contact with heat sources.
Before washing for the first
time
The washing machine was thoroughly
tested before leaving the factory. To
remove any residues from the product
and to remove water that may be left
over from the test, run the first wash
cycle
without
any laundry.
Note:
The washing machine
must be
correctly
installed
and
connected
.
1.
Check the appliance.
Note:
Never use a damaged
machine. Inform the after-sales
service.
2.
Remove the protective foil from the
worktop and the control panel.
3.
Connect the mains plug.
4.
Turn on the water tap.
5.
Do not load any laundry. Close the
door.
6.
Depending on the model, run the
Drum clean
*
or
Cottons
90 °C
programme.
7.
Open the detergent drawer.
8.
Pour approximately 1 litre of water
into compartment
II
.
9.
Pour standard detergent into
compartment
II
.
Note:
To prevent foaming, only use
half the amount of detergent
recommended by the detergent
manufacturer. Do not use detergents
designed for wool or delicates.
10.
Close the detergent drawer.
11.
Press the
I
button.
12.
When the programme ends, switch
off the appliance.
Your washing machine is now ready to
use.
* depending on the model
www.devicemanuals.eu/
