Siemens WG44G2MEDN, Руководство пользователя и инструкции по установке

Страница: 31 / 52

operation
en
31
13.8 Starting the programme
Note:
If you want to change the time
until the programme ends, set the
"Ready in" time first.
▶
Press .
a
The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a
The display shows either the pro-
gramme duration or the "Ready in"
time.
a
After the programme has ended,
the display shows: "End".
13.9 Soaking laundry
Note:
No additional detergent is re-
quired. The washing solution is then
used for washing.
1.
Start the programme.
2.
To pause the programme, after ap-
prox. 10 minutes, press
.
3.
To resume the programme, after
the desired soaking time, press
.
13.10 Adding laundry
1.
Press .
The appliance pauses.
Note:
If appears, it is not pos-
sible to add laundry.
When goes out, it is possible to
add laundry.
2.
Open the appliance door.
3.
Add or remove laundry.
4.
Close the appliance door.
5.
Press .
13.11 Cancelling the pro-
gramme
1.
Press .
2.
Open the appliance door.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the
Rinse
programme.
– If the water level is high, start
the
Spin
programme or select a
suitable programme for draining.
→
"Programmes", Page 24
3.
Remove the laundry → Page 31 .
13.12 Resuming the pro-
gramme when the pro-
gramme status is Rinse
Hold
1.
Start the
Spin
programme or se-
lect a suitable programme for
draining.
→
"Programmes", Page 24
2.
Press .
13.13 Unloading the laundry
1.
Open the appliance door.
2.
Remove the laundry.
13.14 Switching off the appli-
ance
1.
Turn the programme selector to .
2.
Turn off the tap.