en
Operating the appliance
44
Starting the programme
Touch and hold
I
button for 1~2
seconds, then release the button. The
programme starts and the appliance
door is locked.
The finish-in time is shown in the display
panel and counts down until the
programme starts. After the programme
has started, the programme duration is
displayed. And the symbols for the
programme progress are lighting up.
Note:
Foam detection
If the symbol
o
also lights up in the
display panel, the appliance has
detected too much foam during the
wash cycle and automatically activated
additional rinse cycles to remove the
foam.
Childproof lock
You can lock the appliance to prevent
the functions you have set from being
changed inadvertently. To do this,
activate the childproof lock.
To activate the childproof lock:
After the programme starts, Touch and
hold the
w
3 sec
button for 3 seconds.
■
w
3 sec
lights up: The childproof
lock is activated.
■
w
3 sec
flashes: If the programme
and programme settings are
adjusted while childproof lock is
activated.
Note:
When the programme ends,
End
is displayed. The door is unlocked.
w
3 sec
remain on to remind you to
deactivate the childproof lock.
To deactivate the childproof lock:
Touch and hold the
w
3 sec
button
until the
w
3 sec
indicator lamp is off.
Adding/removing laundry
After starting the programme (only for
washing), you can add or remove
laundry if necessary.
Touch the
I
button. The appliance
checks whether reloading is possible.
If the following appears on the display
panel:
■
The symbol
Õ
disappears,
reloading is possible.
■
The symbol
Õ
lights up, reloading is
not possible.
To continue the programme, touch the
I
button. The programme continues
automatically.
Notes
■
Do not leave the door open for too
long when adding laundry as water
from the laundry may leak out.
■
For safety reasons, the door remains
locked when the water level or
temperature is high, or while the
drum is turning, and it is not possible
to add laundry during this time.
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
1.
Touch the
I
button.
2.
Select another programme.
3.
And touch the
I
button again. The
new programme starts from the
beginning.
Note:
If drying is activated, you have to
switch the appliance off and on again to
change the drying programme.