en
Faults and what to do about them
32
Faults and what to do about
them
hot
The door cannot be opened after the drying programme due to the high temper-
ature. The cooling down process will continue until the display disappears and
the door can be opened.
|
■
Flashes
(no water supply): Tap turned on? Inlet filter blocked? Clean the
inlet filter
Supply hose kinked or blocked?
■
Lights up
(low water pressure): For information only. This will not extend
the programme duration.
E:18
Drain pump blocked; clean the drain pump. Clean the drainage hose
on the siphon.
ªªª
■
Hold down button
Ù
(
Drying
) for 3 s to clear this display.
■
Clean the air inlet filter
■
Run the
Fluff Clean
7
programme without laundry.
LO kg
,
HI kg
Laundry amount information. On when drying phase finished.
LO kg
: Signals a small load for drying,
HI kg
: Signals a very high load for drying.
Other displays
Turn the programme selector to
$
Off
. The appliance is switched off. Wait 5 s
and switch on again. If the display is indicated again, call customer service.
Display
Cause/Remedy
Faults
Cause/Remedy
Water is running out.
■
Correctly attach/replace drainage hose.
■
Tighten the screw connection of the supply hose.
No water supply.
Detergent not dispensed.
■
Start
/Reload
!
not selected?
■
Tap not open?
■
Filter blocked? Clean the filter
■
Supply hose kinked or jammed?
The washer dryer door
cannot be opened.
■
Safety function active. Programme stopped?
■
– – –
(
Rinse stop
= without final drain/spin cycle) selected?
■
Can be opened with emergency release only?
■
Childproof lock active? Deactivate.
Programme does not
start.
■
Start
/Reload
!
or
0
(
Finish in
) selected?
■
Door closed?
■
Childproof lock active? Deactivate.
Detergent solution is not
drained.
■
– – –
(
Rinse stop
= without final drain/spin cycle) selected?
■
■
Clean outlet pipe and/or drainage hose.
Water not visible in the
drum.
Not a fault – water below the visible area.
