en
Operating the appliance
18
Childproof lock
You can secure the washer dryer to
prevent the set functions from being
changed inadvertently. To do this,
activate the childproof lock when the
programme has started.
Activating/deactivating: Touch and hold
the button
Start delay
for approx. 5 s.
The symbol
w
is indicated in the
display. If the button signal is activated,
an acoustic signal sounds.
■
w
lights up: The childproof lock is
activated.
■
w
flashes: The childproof lock is
active and the programme selector
has been adjusted. To prevent the
programme from terminating, reset
the programme selector to the initial
programme. The symbol lights up
again.
Note:
The childproof lock may remain
activated until the next programme
starts, even after the washer dryer has
been switched off. If this is the case,
deactivate the childproof lock before the
programme starts and, if required, re-
activate after the programme starts.
Reloading the laundry
When the programme has started, the
laundry can be reloaded or taken out as
required.
Select
Start/Reload
. The washer dryer
checks whether reloading is possible.
Notes
■
If there is a high water level, high
temperature or if the drum is
rotating, the door remains locked
for safety reasons and reloading is
not possible.
If the following is indicated on the
display panel:
A:02
+
PAUS
~
Reloading is not
possible. To continue the
programme, select the
Start/Reload
button.
«
+
OPEn
are lit
~
Reloading is
possible.
■
Do not open the door until
both
the
symbols
«
+
OPEn
are lit.
■
Do not leave door open for
a prolonged period – water could
run out of the laundry.
■
The reloading function cannot be
activated during the drying phase.
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
1.
Select
Start/Reload
.
2.
Select another programme. If
required, adjust the default settings
and/or select additional functions.
3.
Select
Start/Reload
. The new
programme starts from
the beginning.
Interrupting or ending the
programme
For programmes at high temperature:
1.
Select
Start/Reload
.
2.
To cool down laundry: select
Rinse
.
3.
Select
Start/Reload
.
For programmes at low temperature:
1.
Select
Start/Reload
.
2.
Select
Spin
or
Drain
3.
Select
Start/Reload
.
