Siemens TS1 Standard Push Button
For EZ Rebuild Kits Or Tech Support, Contact 1-800-SCORE-OK or Visit www.ScoreDental.com
Required
Tools
SI01KIT
107-2057
Step 1
After reviewing the training video and step-by-step
instruction sheet, install the blank bur provided with
your EZ Press and check to make sure that the
spindle/chuck is holding the bur. If bur pulls out call
Score for replacement spindle/chuck.
Siemens TS1 Standard PB is a tradename and is not affiliated with Score Intl.
Bearing Kit
Turbine
Rear
Bearing
Front
Bearing
CAUTION: Could result in damage to parts
!
WARNING:
Could result in handpiece malfunction
!
Spindle
DR70B3L
Step 2
Loosen headcap using appropriate cap wrench and
remove turbine. If head cap and turbine come out
together, separate and set head cap aside. Place Insert B
underneath the Spindle Ram on the left side of the press.
Place the turbine in the center of Insert B with the bur going
down through the hole in the center.
Step 3
Locate the EZ Push-Button Protector that was included
with the press. Insert the skinny end up into the Spindle
Ram on the left and hold in place with your fingers.
Slowly pull the handle down until the protector meets
the rear of the spindle and covers the button.
Step 4
Make sure everything is aligned and pull down or tap the
handle firmly to push out the spindle/chuck and disassemble
the turbine. The spindle/chuck will fall into the tray below.
Step 5
The old bearings and impeller will remain sitting on Insert B.
Discard the bearings and inspect the impeller any chips,
cracks or worn blades. If the impeller has any damage call
Score for a replacement.
Step 6
Place Insert #1 underneath the Bearing Ram on the right
side of the press. Open your rebuild kit and pick up one of
the bearings. Pick up the spindle/chuck and hold it so the
bur points up. Drop the bearing over the bur so the silver
shielded faces down, away from the bur and the black side
faces up.
HSM855-70822
107-7037
Headcap
TSP525
DR70B3L
Genuine
EZ
Rebuild Kit
TM
by
1-800-726-7365
EZ
Turbine
by
Install
O-ring
HSM165
O-ring
HSM165
EZ Push-Button
Protector
(EZ301PBP)
Blank Bur
(HMW271-1)
Insert B
(EZ301BAIB)
B
4
Insert 4
Cap Wrench
TST903
Impeller
HSM343
