Siemens TE603, Инструкция по эксплуатации

Страница: 12 / 164

8
en
Initial use
General
Fill the appropriate container using only
pure, cold , uncarbonated water and solely
roasted beans (preferably espresso or
coffee bean blends for fully automatic coffee
machines)� Do not use coffee beans that
have been glazed, caramelised or treated
with other additives containing sugar, since
they will block the brewing unit�
The water hardness setting on the
appliance can be adjusted� The factory
setting for the water hardness is 4� Use
the enclosed test strip to determine the
hardness of your water supply� If this
shows a value other than 4, you will need
to programme the appliance appropriately
after it has been taken into service (see
section “Menu –
Water hardness
”)�
Setting up the appliance
● Remove any protective plastic film.
● Place the fully automatic coffee machine
on a level, waterproof surface that is able
to support its weight�
● The appliance’s ventilation slits must not
be covered or obscured�
F
Important:
Only use the appliance
in a frost-free room� If it has been
transported or stored at tempera-
tures below 0°C, wait at least 3 hours
before taking it into operation�
● Pull the mains plug out of the cable storage
compartment 18 and connect it to the
power supply� You can adjust the length of
the cable by pulling it further out or pushing
it back in� To do this, place the appliance
with its back flush with the edge of the
work surface and either pull the cable out
downwards
or push it in
upwards
�
● Flip up the lid of the water tank 6 �
● Remove the water tank 5 , rinse it out and
fill it with fresh cold water. Do not fill it
past the “ max ” mark�
● Replace the water tank 5 , making sure
that it is straight, and push it right down
into place�
● Reclose the lid of the water tank 6 �
● Fill the bean container 9 with coffee beans�
● Use the main switch
J
1 to switch on the
appliance�
The control panel and the display will
be activated� The display will show the
previously specified language, which will
also be used for all subsequent display
texts� A number of different languages are
available�
● Touch
I
repeatedly until the display
indicates the desired language�
Deutsch
English
Français
● Touch
C
to confirm your
selection�
The chosen language is now stored�
The brand logo will light up on the display 3 �
The appliance will heat up and rinse itself,
a small amount of water will run out of the
drink outlet 4 �
The appliance is ready for use when the
symbols and the display on the control
panel are lit�