Siemens te501 series, Инструкция по эксплуатации

Страница: 21 / 117

21
en
Problem Cause Remedy
Coffee is too “bitter”. The grind setting is too fine
or the pre-ground coffee is
too fine.
Adjust the grinding unit to
a coarser setting or use
coarser pre-ground coffee.
Unsuitable type of coffee. Change the type of coffee.
The water filter does not
stay in position in the water
tank (16).
The water filter is not fitted
correctly.
Firmly press the water filter
straight down into the tank
connection.
The coffee grounds are not
compact and are too wet.
The grind setting is too fine
or too coarse, or not enough
ground coffee has been
used.
Adjust the grinding unit to
a coarser or finer setting,
or use 2 level measuring
spoons of ground coffee.
LED
D
lights up
Water tank has been
incorrectly inserted or the
new water filter has not
been rinsed according to
instructions.
Insert the water tank
correctly or rinse the water
filter according to instruc-
tions and then switch on.
LED
I
flashes.
Brewing unit (5) is soiled. Clean the brewing unit (5).
Too much pre-ground coffee
in the brewing unit (5).
Clean the brewing unit (5)
(Put in no more than 2 level
measuring spoons of ground
coffee).
The brewing unit
mechanism is stiff.
Remove and clean the
brewing unit , see “Mainte-
nance and daily cleaning”.
Coffee or milk froth quality
varies widely.
Build-up of limescale in the
appliance.
Descale the appliance with
two descaling tablets as de-
scribed in the instructions.
Water dripped onto the in-
ner floor of the appliance
when the drip tray (8) was
removed.
Drip tray (8) removed too
soon.
Wait a few seconds after
the last drink was dispensed
before removing the drip
tray (8).
LED
I
lights up.
Brewing unit (5) is missing
or has not been detected.
Switch off the appliance
with the brewing unit (5) in
place, wait three seconds
and switch on the appliance
again.
If you are unable to solve the problem, please call the hotline.
You will find the telephone numbers at the back of these instructions.
Simple troubleshooting