Siemens Synco 900, Монтаж и пусконаладка

Страница: 61 / 88

61/88
Siemens Synco 900 CE1C2707en
Building Technologies Commissioning the system 05.07.2007
Programming mode
If you want to assign the device address in KNX system mode (with
ETS), activate the addressing mode (On) via the following operating
line.
Main menu > Commissioning > Bus communication >
Basic settings > Programming mode:
Factory setting Off
Your setting Off
On
Clock time operation
When using setting “Autonomous“, the device does not receive or
send the time of day. If the system is to use a common time of day,
one of the devices must be defined as the clock time master and the
others as slaves.
Main menu > Commissioning > Bus communication >
Time of day/date > Clock time op:
Factory setting Autonomous
Your setting Autonomous
Slave
Master
Ensure that only one device in the system is defined as the
clock time master.
Remote setting clock slave
Function “Remote setting clock slave = Yes“ enables the user to also
set the time of day and the date on a clock time slave.
The new values is transmitted to the clock time master via the Kon-
nex bus. The clock time master distributes the new time to all bus
users. Hence, for the plant user, operation is the same as that on the
clock time master.
Main menu > Commissioning > Bus communication >
Time of day/date > Rem set clock slave:
Factory setting Yes
Your setting Yes
No