en
Rinse aid system
30
stances. According to manufactur-
ers, combined detergents with salt
replacement substances can gen-
erally only be used up to a water
hardness of 26 °E without adding
special salt.
¡
The water hardness is 0 - 8 °E.
You do not need to use special
salt.
1.
Press .
2.
To open the basic settings, press
for approx. 3 seconds.
3.
Press repeatedly until the display
shows "Water hardness".
4.
Press or repeatedly until the
display shows 0 - 8.
5.
To save the settings, press for
approx. 3 seconds.
a
The water softening system is
switched off and the salt refill indic-
ator is deactivated.
Regeneration of the water
softening system
In order to obtain fault-free function of
the water softening system, the appli-
ance performs regeneration of the
water softening system at regular in-
tervals.
Regeneration of the water softening
system takes place before the end of
the main rinse cycle in all pro-
grammes. It will increase the run time
and consumption values, e.g. water
and electricity.
Overview of consumption values
with regeneration the water
softening system
Here you can find an overview of the
maximum additional run time and
consumption values during regenera-
tion of the water softening system.
Regeneration of the water softening
system after x rinse cycles
6
Additional run time in minutes
7
Additional water consumption in
litres
5
Additional power consumption in
kWh
0.05
The consumption values specified
are laboratory measurements determ-
ined in accordance with the currently
applicable standard and using the
Eco 50° programme and the factory
value of the water hardness is set to
16 - 20°E.
Rinse aid system
Rinse aid system
Rinse aid system
Rinse aid
For optimum drying results, use rinse
aid.
Only use rinse aid for domestic dish-
washers.
Adding rinse aid
If the display shows "Please add
rinse aid. ", add rinse aid. Only use
rinse aid for domestic dishwashers.
1.
Press the catch on the lid of the
dispenser for rinse aid and lift
.
1
2
Содержание SN87Y801BE
Страница 67: ......
