Siemens SN53HS60AE, Инструкция по эксплуатации

Страница: 26 / 64

NLSoftening System
NoteSet the device to the
determined water hardness.
→ †Set water softening", page
26
With a water hardness of 0 - 6 °dH you
do not need to use softening salt and
you can switch off the water softening.
→ †Switching off water softening",
page 27
water hardness, the greater the
amount of softening salt required.
PAY ATTENTION!
†Dishwasher detergent can damage the water
damage hardening.
▶ Only fill the water softener
reservoir with dishwasher
softening salt.
†The rinse aid container can be
corrode softening salt.
▶
To ensure that spilled softening
salt is rinsed out of the rinse aid
container, fill the softening salt
into the softening salt reservoir
immediately before the program
starts.
Set water softening
Set the device to the water hardness.
1.
Determine the water hardness and the
desired setting value.
→ †Overview of the water
hardness settings", page 25
2.
Press.
3.
Approx. 3 seconds on
to access the basic settings.
Busy-
1.
Open the lid of the softening salt
reservoir and remove it.
aThe display shows Hxx. aThe
display shows
2.
When using for the first time: fill the
reservoir completely with water.
reflected
to give.
3. NoteOnly use dishwasher
softening salt.
Do not use salt tablets. Do not
use table salt.
4.
Just as often on
the desired water hardness has
been set.
press until
The factory setting is H04.
5.
To save the settings, press . for
about 3 seconds to press.
Place the softening salt in the
softening salt reservoir.
Softening salt
You can soften the water with
softening salt.
Filling softening salt
If the Refill softener salt indicator
lights up, top up the softener salt in
the softener salt reservoir
immediately before the program
starts. The amount of softening salt
required depends on the water
hardness. The higher the
26