en
16
Remaining running time display
When the programme is selected, the
remaining running time of the programme
is indicated on the digital display
10
.
The running time is determined during the
programme by the water temperature, the
number of utensils as well as the degree
of soiling and may vary (depending on the
selected programme).
Timer programming *
* depending on model
You can delay the start of the programme
in 1-hour steps up to 24 hours.
Close the door.
Switch on ON/OFF switch
1
.
Press
4
+ button until the digital
display
10
jumps to
.
Press
4
+ or – button until the
displayed time corresponds with
your requirements.
Press START button
6
, timer
programming is activated.
To delete timer programming, press
the
4
+ or – button until
is indicated on the digital display.
You can change your programme
selection at any time until the
programme starts.
End of programme
The programme has ended when the
value
is indicated on the numerical
display
10
.
Switching off the appliance
Short time after the end of the programme:
Switch off ON/OFF switch
1
.
Turn off the tap (not applicable
if Aqua-Stop fitted).
Remove the utensils when they
have cooled down.
Warning
At the end of the programme please open
the door fully and not partially when
emptying the dishwasher. Any escaping
water vapour could damage sensitive
worktops.
Interrupting the programme
Switch off ON/OFF switch
1
.
The LEDs go out. The programme
is saved.
If the door was opened on an appliance
which has a warm water connection or
is heated, first leave the door ajar for
several minutes and then close.
Otherwise, expansion (pressure) may
cause the appliance door to spring
open or water to run out of the
appliance.
To continue the programme, switch on
the ON/OFF switch
1
again.
Terminating the programme
(Reset)
Press START button
6
for approx.
3 sec.
The numerical display
10
indicates
.
The programme sequence lasts
approx. 1 min.
On the digital display
10
is indicated
.
Switch off ON/OFF switch
1
.
Downloaded from DishWasher-Manual.com Manuals