Siemens SMART GATE S-80, Быстрый старт

Страница: 35 / 54

ENTRANCE GATE INSTALLATION AND SETUP
4-11
SIG-QG-21-01 NOVEMBER 2021
Version: A
c. Remove the lock bar from the ½” hex of the gearmotor output shaft (use the 5/16”
wrench to rotate the brake end of the motor as necessary, to relieve pressure from the
lock bar).
d. Release the motor brake by removing the 5/16” inch wrench. The Gate arm will
descend to the horizontal position in a controlled manner.
e. Reapply power to the gate mechanism by closing the test links on Terminals 4 and 5 (if
previously removed).
The following table provides counterweight and torque guidelines for fiberglass/aluminum gate arms.
Table 4-2 Fiberglass/Aluminum Gate Arm Counterweights and Vertical Torque
Gate Arm
Length (ft)
Counterweights
Required
Stud Plate
NYK: 070757
Gear Motor Output
Shaft Torque
(inch-pounds)
Main Shaft
Torque
(foot-pounds)
Std. Short Std. Short Min Max Min Max
Counterweights
mounted on one
Support Arm
12’ – 15’ 1 3 -26X -30X 64 75 175 205
16’ – 20’ 2 5 -26X -30X 64 77 175 210
21’ – 22’ 3 7 -26X -30X 64 77 175 210
23’ – 27’ 4 10 -26X -30X 70 84 190 230
28’ – 32’ 5 10 -26X -30X 86 96 235 260
Counterweights
mounted on two
Support Arms
33’ – 36’ 6 13 -26X(2) -30X(2) 96 110 260 300
37’ – 40’ 7 17 -26X(2) -30X(2) 110 129 300 350
NOTE
The values listed in the table above are approximate as there are differences
between various gate arm manufacturers.
NOTE
Due to variations in gate arm cross sections, arm material, gate arm lights,
and gate arm adapters, torque must be checked. Table 4-2 is a rough
approximation when using a conversion bracket.