Siemens SINUMERIK 840Di sl, Руководство по вводу в эксплуатацию

Страница: 478 / 632

NC Commissioning with HMI Advanced
11.8 Loadable compile cycles
Manual
478
Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
11.8 Loadable compile cycles
Product brief
Compile cycles are functional expansions of the NC system software that can be created by
the operator and/or by Siemens and then imported in the control later.
As part of the open NC system architecture, compile cycles have comprehensive access to
data and functions of the NC system level via defined software interfaces. Therefore, you
can use compile cycles to expand the functionality of the NC as much as you require or
redefine it as far as allowed by the interfaces.
Including a compile cycle in the NC system software is performed by loading the compile
cycle into the file system of the NC. The compile cycle can be loaded at any time.
Siemens compile cycles
The following technological functions and more are available from Siemens in the form of
compile cycles:
●
1D/3D clearance control in position controller cycle
References:
/FB3/ Function Manual - Special Functions
Chapter "Clearance Control" (TE1)
● Continue machining at the contour (retrace support)
References:
/FB3/ Function Manual - Special Functions
Chapter "Continue Machining Retrace Support (TE7)
● Fast laser switching signal
References:
/FB3/ Function Manual - Special Functions
Chapter "Cycle-independent Path-Synchronous Control Signal Output (TE8)
When you order one of the listed technological functions, you are given the corresponding
software license number. To obtain the compile cycle in the form of a loadable file (.ELF
extension for executable and linking format), please contact your regional Siemens sales
partner.
Note
Compile cycles created by Siemens are options that require explicit activation and licensing.
References:
Ordering information in Catalog NC 61