Siemens SINUMERIK 840D sl, Руководство по эксплуатации

Страница: 597 / 942

Input simple
For simple machining operations, you have the option to reduce the wide variety of parameters
to the most important parameters using the "Input" selection field. In this "Input simple" mode,
the hidden parameters are allocated a fixed value that cannot be adjusted.
Machine manufacturer
Various defined values can be pre-assigned using setting data.
Please refer to the machine manufacturer's specifications.
If the workpiece programming requires it, you can display and change all of the parameters
using "Input complete".
Machining type
You can select the machining type (roughing, base finishing, edge finishing, chamfer) for
milling. If you want to rough and then finish, you have to call the machining cycle twice (block
1 = roughing, block 2 = finishing). The programmed parameters are retained when the cycle is
called for the second time.
Approach/retraction
1. The tool approaches the starting point at rapid traverse at the height of the retraction plane
and is fed in to the safety clearance. The cycle calculates the starting point.
2. The tool first infeeds to the machining depth and then approaches the spigot contour from
the side in a quadrant at machining feedrate.
3. The spigot is machined in parallel with the contours from the outside in. The direction is
determined by the machining direction (climb/conventional) (see "Changing program
settings").
4. When the first plane of the spigot has been machined, the tool retracts from the contour in
a quadrant and then infeeds to the next machining depth.
5. The spigot is again approached in a quadrant and machine in parallel with the contours from
outside in.
6. Steps 4 and 5 are repeated until the programmed spigot depth is reached.
7. The tool retracts to the safety clearance at rapid traverse.
Programming technology functions (cycles)
10.5 Contour milling
Turning
Operating Manual, 06/2019, A5E44903486B AB
597