Siemens SINUMERIK 840D sl, Руководство по эксплуатации

Страница: 434 / 942

Hidden parameters
The following parameters are hidden. They are pre-assigned fixed values or values that can be
adjusted using setting data.
Parameter Description Value Can be set in SD
PL Machining plane Defined in MD
52005
G Change in thread pitch per revolution – (only for P = mm/rev or
in/rev):
Without change in thread pitch
0
D0 Initial plunge depth for reworking the threads 0 mm
½ Halve first infeed depth Yes
VR Return distance 2 mm x
Multiple threads 1 thread No
α0 Starting angle offset 0°
Machine manufacturer
Please refer to the machine manufacturer's specifications.
10.2.7 Thread chain (CYCLE98)
Function
With this cycle, you can produce several concatenated cylindrical or tapered threads with a
constant pitch in longitudinal and face machining, all of which can have different thread pitches.
There may be single or multiple threads. With multiple threads, the individual thread turns are
machined one after the other.
You define a right or left-hand thread by the direction of spindle rotation and the feed direction.
The infeed is performed automatically with a constant infeed depth or constant cutting cross-
section.
● With a constant infeed depth, the cutting cross-section increases from cut to cut. The
finishing allowance is machined in one cut after roughing.
A constant infeed depth can produce better cutting conditions at small thread depths.
● With a constant cutting cross-section, the cutting pressure remains constant over all
roughing cuts and the infeed depth is reduced.
The feedrate override has no effect during traversing blocks with thread. The spindle override
must not be changed during the thread machining.
Programming technology functions (cycles)
10.2 Rotate
Turning
434
Operating Manual, 06/2019, A5E44903486B AB