Siemens Simatic RTU3030C, Руководство по эксплуатации

Страница: 35 / 392

Application and functions
1.8 Other services and properties
RTU303xC
Operating Instructions, 06/2019, C79000-G8976-C382-06
35
● IP configuration
The essential features of IP configuration are as follows:
–
VLAN interface and the WAN interface of the RTU support IP addresses according to
IPv4.
– Address assignment of the LAN interface
The IP address and the subnet mask can be set manually in the configuration.
The IP address can also be assigned automatically by the DHCP client function of the
RTU.
If the DHCP server function of the RTU is enabled, for the configuration PC to be
connected the IP address is assigned by the RTU in the network (normally the next
free address).
– Address assignment for the default router and DNS servers
The addresses can be assigned manually or automatically with the DHCP client
function of the RTU. The RTU tells the DHCP server its own station name so that it
can register the name with its DNS server, if supported.
● Time-of-day synchronization
The RTU has the following options for time-of-day synchronization:
–
NTP
Time synchronization is carried out via SNTP (Simple Network Time Protocol).
– By mobile wireless network
Possible if the network provider supports the NITZ mechanism (Network Identity and
Time Zone).
– By telecontrol master station
If the RTU has a communications partner in the master station, it should always obtain
its local time of day from the partner.
In most cases, the time of day is transferred as UTC time.
When using the ST7 protocol the time of day is transferred as the local time of the
control center.
PCS 7 as master transfers the time of day with the DNP3 protocol as UTC and with
the IEC protocol as the local time of the PCS 7 PC.
– GPS
Time-of-day synchronization can take place via GPS with RTU3031C .
For more information, refer to the section System time (Page 116).
For information on the format of the time stamp, refer to the section Overview (Page 178).