Siemens SIMATIC NET RUGGEDCOM RS400F, Руководство по установке

Страница: 33 / 48

Communication Ports
4.4.3 Serial RS232/RS485/RS422 RJ45 Ports
b
The Common terminal is optically isolated. However, there is transient voltage protection circuitry
between the Common terminal and chassis ground.
c
Pins 7 and 8 are connected together internally. In RS232 mode, these pins enter a high impedance
state. A DTE that asserts RTS will see CTS asserted, although the device will not perform hardware flow
control.
4.4.3 Serial RS232/RS485/RS422 RJ45 Ports
The RUGGEDCOM RS400F can be equipped with serial RS232/RS485/RS422 RJ45
ports. Each port can be set individually through the RUGGEDCOM RS400F operating
system to operate in RS232, RS485 or RS422 mode. For more information, refer to
the RUGGEDCOM ROS Configuration Manual for the RUGGEDCOM RS400F.
The following is the pin-out description for the RS232/RS485/RS422 RJ45 ports:
1 8
Figure 4.10 RS232/RS485/RS422 RJ45 Ser-
ial Console Port
Name Pin
a
RS232
Mode
RS485
Mode
RS422
Mode
1 DSR
b
RX-
2 DCD
b
3 DTR
b
4 Common (Isolated) Ground
5 RXD
c
RX+
6 TXD
c
TX/RX+ TX+
7 CTS
8 RTS TX/RX- TX-
Shield Chassis Ground
a
No internal termination is provided.
b
The DSR, DCD and DTR pins are connected together internally.
c
In RS232 mode, the RJ45 ports conform to EIA-561 DTE, which transmit on TXD and receive on RXD.
4.4.4 Serial Insulated Terminals
The RUGGEDCOM RS400F can be equipped with serial RS485 insulated terminals. The
terminals are terminated by default from the factory. Termination provided is AC Ter-
mination style 120 Ohm resistor in series with a 10nF capacitor. The following details
the appropriate jumper configuration for each RS485 port.
Jumper Position
Port Jumper Number
No Termination AC Termination
1 JP5
2 JP6
3 JP7
4 JP8
Removed Installed
24
RUGGEDCOM RS400F
Installation Manual, 02/2020, C79000-G8976-1341-04