Siemens SIMATIC IPC647E, Руководство по эксплуатации

Страница: 54 / 200

Installing and connecting the device
3.3 Connecting the device
SIMATIC IPC647E
54
Operating Instructions, 11/2018, A5E45589180-AA
Connecting several monitors (multi-monitoring)
You will find up to six ports on the rear of the device for connecting monitors. Of these, three
ports are connected to the motherboard. When installing an optional graphics card, the other
three ports are connected to the graphics card. Parameter assignment is performed by
means of the Control Panel in Windows®.
You can configure the multi-monitoring function and the output of the boot screen in the
firmware settings, see "Multi-monitoring (Page 61) ".
The following table shows the various connection options for the monitors on the device
interfaces.
Motherboard Graphics card (optional)
DPP1 DPP2 DVI mDPP1 mDPP2 mDPP3
Monitor 1 DP X - - - - -
DVI X
1)
- - - - -
VGA X
2)
- - - - -
Monitor 2 DP - X - - - -
DVI - X
1)
- - - -
VGA - X
2)
- - - -
Monitor 3 DP - - - - - -
DVI - - X - - -
VGA - - - - - -
Monitor 4 DP - - - X
3)
- -
DVI - - - X
4)
- -
VGA - - - X
5)
- -
Monitor 5 DP - - - - X
3)
-
DVI - - - - X
4)
-
VGA - - - - X 5) -
Monitor 6 DP - - - - - X
3)
DVI - - - - - X
4)
VGA - - - - - X
5)
1) - via DP to DVI-D adapter
2) - via DP-VGA adapter
3) - via mDP-DP adapter
4) - via mDP to DVI-D adapter
5) - via mDP-VGA adapter
You can find information on the optional graphics card under "Technical specifications of
graphic (Page 151)".