Siemens SIMATIC FM 455 C, Начало работы

Страница: 11 / 20

Learning units
3.3 Preparations for programming
3.3
3.3
Preparations for programming
Procedure
1. Open your project in SIMATIC Manager (see the
Controller Module FM 455 manual,
chapter "Assigning parameters to FM 455".)
2. Open the "HW Config" configuration table In your project.
3. Select the FM 455 C with order no. 6ES7 455-0VS00-0AE0 from the hardware catalog,
then drag-and-drop it to the required slot (in our example: slot 5.)
4. Open the "Properties - FM 455 C PID Control" dialog box by double-clicking this
FM 455 C.
5. Note down the module address defined in the addresses tab (in this example:
512 = 200H.) You need this address in the next step to integrate the FM 455 C in the user
program.
6. Check out the "basic parameters":
–
Interrupt generation: none
–
Interrupt selection: none
This setting prevents the FM from outputting a diagnostics interrupt to the CPU after a
transducer error has been detected (see the
Controlle Module FM 455 r
manual, chapter
"Faults and diagnostics".)
Click Parameters... to open the programming interface. The next sections will only deal with
parameters required for the sample project. We are not going to show and describe all
programming interfaces.
FM 455 C
Getting Started, 02/2006, A5E00059365-03
3-3