Siemens SIMATIC ET 200iSP, Руководство по эксплуатации

Страница: 127 / 384

Uninstalling interface module and electronic modules
1. Use the screwdriver to operate the catch on the underside of the interface or electronic
module.
2. Swivel this upward.
3. Remove the module from the storage space of the terminal module.
Figure 5-14 Uninstalling interface and electronic modules
Replacing a defective interface or electronic module
You have already uninstalled the interface or electronic module:
1. remove the removable part of the coding element from the new interface or electronic
module. The coding element is located on the underside of the interface or electronic
module.
2. Install the new interface or electronic module (same type) on the terminal module, checking
for an audible latching sound.
3. Label the new interface or electronic module.
Note
Check the coding element before you install the new interface or electronic module.
Wiring
5.5 Inserting and labeling the power supply, interface module, and electronic modules
ET 200iSP
Operating Instructions, 11/2017, A5E00247483-07
127